Installing an AgriCamera Revolution Camera

AgriCamera Revolution

The following steps are what you need to do in order to setup one of our AgriCamera Revolution Cameras

1

Cut/drill out one of the 3 slots in the side of the bracket for the camera cable.

Note - make sure that no sharp edges are left that could damage the cable.

2

Run the cable from the camera through the bracket.

3

Attach the camera to the bracket using the 3 small screws and allen key provided.

4

Mount the bracket to the wall/beam with the cable coming through the hole you cut out.

Note – When choosing where to mount the camera. Take a look at what you can see. The camera can move and zoom in but can’t see around corners

5

Mount the camera connection box on the wall/beam next to the camera.

6

Cut out a “cross” in the grommet for the cable to pass through

Note – Cutting from the bottom of the grommet will help it hold its shape.

7

Feed the cables through into the connection box. Connect the connection cable into the ethernet port.

8

Shut the box up and do up the screw to seal. 

Helpful tip – A drip loop will prevent any water tracking back down the cable into the connection box. 

9

Before you finish, make sure you have removed the transport lock and fiberglass tape. This stops the lens moving and getting damaged in transport.

10

The transport lock must be removed before you switch the camera on. It can damage the camera if switched on before the transport lock is removed. This will void the warranty.