Installing an AgriCamera Bullet Camera

AgriCamera Bullet Camera

The following steps are what you need to do in order to set up one of our AgriCamera Revolution Cameras

1

Attach the camera bracket to the wall.

Note – the grub screw can be undone with the allen key provided to allow you to separate the arm from the bracket.

2

Adjust the camera angle so the camera faces in the right direction. Tighten each of the three grub screws to fix the camera in position.

3

Connect the cable into the camera connection box.

Note – If needed, you can disconnect the connection box from the white cable from the camera to poke through a hole. Please be very careful when doing this. It only fits in one way and should slide in with little force. Make sure the locking thread is done up tightly.

4

Mount the camera connection box on the wall/beam next to the camera.

5

Cut out a “cross” in the grommet for the cable to pass through

Note – Cutting from the bottom of the grommet will help it hold its shape.

6

Feed the cables through into the connection box. Connect the connection cable into the ethernet port.

7

Shut the box up and do up the screw to seal.

Helpful tip – A drip loop will prevent any water tracking back down the cable into the connection box.